Hey! Trying to draw freehand in Moho 12, but whenever I end a line too close to another point, it snaps to it. I thought turning off "Auto-weld" would stop this, but it doesn't.
Like if I try to write "11" too close together, it just merges both straight lines into a single wavy line, or turns them into a "V", or a weird, pointy ellipse!
Any way to get new lines to completely ignore old lines? Thanks!
Can't completely disable auto-weld?
Moderators: Víctor Paredes, Belgarath, slowtiger
-
- Posts: 41
- Joined: Fri Jun 05, 2009 5:25 pm
- Contact:
Re: Can't completely disable auto-weld?
It should not be doing this. Try saving and shut down the program and re-starting it.
- Víctor Paredes
- Site Admin
- Posts: 5724
- Joined: Wed Jan 26, 2005 12:18 am
- Location: Barcelona/Chile
- Contact:
Re: Can't completely disable auto-weld?
12.0 automatically welds the end points. In a next version, there will be an option to disable it.
Moho Product Manager
Rigged animation supervisor: My father's dragon, Wolfwalkers & Star Wars Visions "Screecher's Reach"
My personal Youtube Channel
-
- Posts: 41
- Joined: Fri Jun 05, 2009 5:25 pm
- Contact:
Re: Can't completely disable auto-weld?
Oh, it's a FEATURE!
Very cool. How far off do you think 12.1 is, Victor?
Very cool. How far off do you think 12.1 is, Victor?
- Víctor Paredes
- Site Admin
- Posts: 5724
- Joined: Wed Jan 26, 2005 12:18 am
- Location: Barcelona/Chile
- Contact:
Re: Can't completely disable auto-weld?
Actually, yes, it's a feature introduced in one of the last stages of 12.0 development and it's very useful in many cases. Then, when the software was released, we received some feedback from users about it, so we decided to make it optional.
There's no official date to share for 12.1 yet, but I can tell you the team is working hard on it.
There's no official date to share for 12.1 yet, but I can tell you the team is working hard on it.
Moho Product Manager
Rigged animation supervisor: My father's dragon, Wolfwalkers & Star Wars Visions "Screecher's Reach"
My personal Youtube Channel
Re: Can't completely disable auto-weld?
What was the reasoning of removing the ability to uncheck the auto weld in 12? I am still using 9.5.Víctor Paredes wrote:Actually, yes, it's a feature introduced in one of the last stages of 12.0 development and it's very useful in many cases. Then, when the software was released, we received some feedback from users about it, so we decided to make it optional.
There's no official date to share for 12.1 yet, but I can tell you the team is working hard on it.
- Víctor Paredes
- Site Admin
- Posts: 5724
- Joined: Wed Jan 26, 2005 12:18 am
- Location: Barcelona/Chile
- Contact:
Re: Can't completely disable auto-weld?
Auto-weld is a different feature and the option to enable/disable it is still there.sbtamu wrote:What was the reasoning of removing the ability to uncheck the auto weld in 12? I am still using 9.5.
Moho Product Manager
Rigged animation supervisor: My father's dragon, Wolfwalkers & Star Wars Visions "Screecher's Reach"
My personal Youtube Channel