I use the command line rendering option in AS and I tried the verbose option of which in the FAQ is written:
-v Runs the rendering job in "verbose" mode. In this mode, Moho will print out messages about its status, including an estimate of the time remaining in the rendering job.
However no output messages are printed in the command line console. Can this be explained?
Gr,
Frank
Command line rendering and verbose mode
Moderators: Víctor Paredes, Belgarath, slowtiger
I can say that vervose mode works on linux version:
Here is an example of the vebose mode result:
-G
Here is an example of the vebose mode result:
Code: Select all
carlos@micasa:~$ AnimeStudioPro/AnimeStudioPro -r Videos/sunset/sunset4.anme -v -f PNG -o Videos/sunset/try5/sunset4.png
Frame 1 (1/252)
Frame 2 (2/252) 25.33 secs/frame 6356.63 secs remaining
Frame 3 (3/252) 25.08 secs/frame 6269.14 secs remaining
Frame 4 (4/252) 24.83 secs/frame 6182.83 secs remaining
Frame 5 (5/252) 23.94 secs/frame 5937.55 secs remaining
Frame 6 (6/252) 23.40 secs/frame 5778.94 secs remaining
Frame 7 (7/252) 23.32 secs/frame 5737.31 secs remaining
Frame 8 (8/252) 23.30 secs/frame 5709.57 secs remaining
Frame 9 (9/252) 23.27 secs/frame 5677.45 secs remaining
Frame 10 (10/252) 23.27 secs/frame 5655.17 secs remaining
Frame 11 (11/252) 23.28 secs/frame 5633.62 secs remaining
Frame 12 (12/252) 23.37 secs/frame 5631.94 secs remaining
Frame 13 (13/252) 23.38 secs/frame 5610.95 secs remaining