Page 1 of 1

X/Y Scaling factor for Noise tool...

Posted: Tue Nov 16, 2004 11:11 am
by 7feet
One more. Ramon Lopez had asked for this, and I don't see anything wrong with more flexibility. Besides, I doubt it took me even 10 minutes. If they were only all this easy. It's such a simple change, I just did it as a straight upgrade. Back up the old one and replace.

lm_noise.lua

Next?

--Brian

Posted: Sat Nov 20, 2004 11:36 am
by Rai López
Well, one more time... THANK YOU!! I only got to add a check box for a scale factor of noise (and take me more than 10 minutes, belive me...), but nothing about X & Y separate adjust, it's simply GREAT!! THANKS AGAIN!

PD: Ah, and THANK YOU too for "Numerical Curvature tool" I requested it too in the past and it is SO USEFULL! :-* (a kiss) Jaja...