Page 1 of 1
cut-off bone dynamics?
Posted: Mon Jun 06, 2005 6:38 am
by umedon
Is it possible to cut-off bone dynamics on particular key-poses?
Because I do not want it to apply all the time.
Thanks.
Re: cut-off bone dynamics?
Posted: Mon Jun 06, 2005 7:02 am
by myles
Hello Umedon,
umedon wrote:Is it possible to cut-off bone dynamics on particular key-poses?
Because I do not want it to apply all the time.
Thanks.
Not yet - but Lost Marble is certainly considering it -
see this thread.
Regards, Myles.
Posted: Mon Jun 06, 2005 11:39 am
by umedon
If I create a switch layer, and switch between the dynamic bones layer and another one (a copy) without the dynamics applied, would it work? (for the moment).
Posted: Tue Jun 07, 2005 1:38 am
by myles
umedon wrote:If I create a switch layer, and switch between the dynamic bones layer and another one (a copy) without the dynamics applied, would it work? (for the moment).
Good idea! Yes, that should work. You may have to keyframe the non-dynamic layer to match the dynamic layer posiiton just before you switch, but that sounds like a good workaround.
Regards, Myles.