question: How to create disconnected stroke with minimum points

[skk]

Hello. Please give me an advice!

I'm trying to make a model with disconnected stroke as you can see in the image below.
(It is only a reference and what I'm trying to make has a little bit more complicated shape)



Next image below is a moho model I created.
left image: added some points and thinner stroke width → but the stroke width gets thin towards the end point.
right image: added more points to adjust the width → It looks good but too many points



I want minimum points for the setup.
So if there is a good way, please teach me!

Thank you.

[Maestral]

Hi!
It looks like you're using the Line Width tool and since you're tinning the line, you need those extra points.
If you try the Hide Edge tool - you'll need just two points, where you want the path to be disconnected.